green house
reduce
If you have any request, please contact us, we will reply you within 24 hours.
What we do
We specializing in the production of Agricultural Gearbox, PTO Shafts, Sprockets, Fluid Coupling, Worm Gear Reducers, Gears and racks, Roller Chains, Sheave and Pulleys, Planetary Gearboxes, Timing Pulleys, Shaft Collars and more.
Greenhouse-reducer(gearbox)
Greenhouse Reducers(gearbox) adopts helical gear and worm gear transmission structure design with high precision. The worm and helical gears are smooth after grinding gear processing, low noise, high output torque and high transmission efficiency.
Using precision aluminum die-casting processing, beautiful appearance, light weight, good heat dissipation and other advantages.
The use of bottom mounting and side mounting makes it easy to install and reduces the labor intensity of the installer.
The product control adopts the spring plate limiting device design, convenient adjustment of the limit, and high positioning accuracy. The stop of the control motor can be arbitrarily adjusted between 1 and 75 rpm. And has a double cutout to ensure safe operation.
After the reducer reaches the end point, restart It can’t work right or wrong.
1, this failure must occur to open the switch box cover, you can find a group Both the upper and lower switches of the switch have been pressed down, loosen the set screws, reset the switch, restart, and observe whether the switch is normal.
2. If there is a situation where the switch is depressed, the corresponding contact should be checked Whether the device is released in time, if it cannot be released in time, consider replacing the contactor.
3. When this type of failure occurs, avoid pressing the contactor and forcibly starting the machine. This will result in damage to the limit, which will inevitably damage the greenhouse structure or cause damage to the reducer gear during operation.
Greenhouse Reducers(gearbox) installation After, both positive and negative Unable to start
2. Check if the phase of the control line is correct. The method is: observe the knurled nut In the direction of movement, use tools to carefully press the lower switch of the front set of switches in the direction of movement of the nut. If it can stop, the phase is correct. If you can not stop, and press a group of lower switches behind the moving direction can make the machine stop, then the phase is reversed, and you need to exchange the phase and try again.
3, check the limit device to see if there is a set of switches up and down both switches In the depressed state, if it is, then loosen the knurled nut to reset the switch and restart it.
Are you looking for the ultimate reliable and universal drive technology for your glasshouse? Why not get in touch with our sales manager？
Contact us
Office Location
Madrid, Community Of Madrid, Spain
Open Hours
M-F: 8am – 6pm, S-S, 9am – 1pm
